Body Kit fitted

DanSE4 · by **DanSE4** » Mon Sep 09, 2013 9:32 am

Good to see a "non-busted" front splitter again mate! :clap:

Teejay · by **Teejay** » Mon Sep 09, 2013 12:39 pm

Lol
Bit of a mini meet, photo session yesterday with Sealysonic and BadKid
BadKid will be doing a thread soon no doubt but here are a couple of quickies I did

Sent from my iPhone using Tapatalk - now Free

rich30mex · by **rich30mex** » Mon Sep 09, 2013 1:11 pm

Nice

kirsty · by **kirsty** » Mon Sep 09, 2013 1:13 pm

looks good hun

**sealeysonic** · by **sealeysonic** » Mon Sep 09, 2013 1:51 pm

Great time was had....however all i can think of is bigger wheels and body kits now lol DAME YOU TREND SETTERS !!!!! lol

EddeyDancer · by **EddeyDancer** » Wed Sep 11, 2013 7:03 am

sealeysonic wrote:Great time was had...
however all I can think of, is bigger wheels and body kits now lol DAME YOU TREND SETTERS !!!!! lol

Mate, I think that the SE6 would look great, with a decent kit and set of wheels!!! :clap:

Teejay · by **Teejay** » Sat Oct 26, 2013 5:38 pm

Spent some time trying to figure out why the n/s rear seatbelt is wet
Finally discovered that the numb nuts who sprayed the car didn't tighten up the nuts that hold the n/s rear window in so rain has been running down the weather strip and seeping in at the corner of the window into the compartment in the boot where the seat belt is installed

Sent from my iPhone using Tapatalk - now Free

stve · by **stve** » Sun Oct 27, 2013 7:03 pm

Looking good fella. great looking bodykit for the calibra in my opinion. def need the skirts to match now and at least 17" wheels to finish the look. Not sure about blending the kit to the body as i think theres always a chance of cracks appearing along the joints as the panels flex.

Teejay · by **Teejay** » Sat Nov 23, 2013 1:41 pm

Installing new rad today , unfortunately new rad is useless as it doesn't have the connections on it for the pipe work for the secondary water pump

Teejay · by **Teejay** » Sat Nov 23, 2013 2:46 pm

Unless suppliers have an alternative, I'm looking at a recore

EddeyDancer · by **EddeyDancer** » Sat Nov 23, 2013 2:59 pm

Mate...

You can swap the side tanks over...

A mate recently had this same issue...

I sent him over the side tank, with the 'Aux Water Pump' fitting...

He heated it up in the oven, in order to fit in back onto the Radiator Core...

Also, I once scored a Radiator off a V6 that didn't even have a fitting for the Aux Water Pump...

It being so cold over there in UK, perhaps it might not be so necessary to have the AWP connected...

Teejay · by **Teejay** » Sat Nov 23, 2013 3:11 pm

Hmmm, might give that a try

Sent from my iPhone using Tapatalk

Teejay · by **Teejay** » Sat Nov 23, 2013 3:16 pm

While the rad is out might as well remove the front a/c rad as it's all disconnected anyway

Sent from my iPhone using Tapatalk

v6 steve · by **v6 steve** » Sat Nov 23, 2013 7:48 pm

couldnt you just cut it in ?

Teejay · by **Teejay** » Sat Nov 23, 2013 10:33 pm

v6 steve wrote:couldnt you just cut it in ?

Eh?
Rad is breached, needs a recore
Managed to get the rad out, also removed the a/c rad as surplus to requirements as a/c is disconnected

Sent from my iPhone using Tapatalk

Body Kit fitted

Re: Body Kit fitted

Body Kit fitted

Re: Body Kit fitted

Re: Body Kit fitted

Re: Body Kit fitted

Re: Body Kit fitted

Re: Body Kit fitted

Re: Body Kit fitted

Body Kit fitted

Body Kit fitted

Re: Body Kit fitted

Re: Body Kit fitted

Re: Body Kit fitted

Re: Body Kit fitted

Re: Body Kit fitted

About Us

Join ClubCalibra!