Outside temperature sensor

Any electrical issues

Outside temperature sensor

by Jordcazorla » Wed Sep 02, 2015 9:24 pm

I've just received my new outside temperature sensor as the display was just showing --.-
Stupidly, I reached around underneath the near side of bumper, found what I thought was where you plug the sensor in to and went and bought the sensor. Received today, gone to connect it up, but doesn't fit the connector, so I've had a further look around that area and found another cable, however whatever was on the end of it has been cut off by a previous owner, is there a way to repair this, ie put a spade connector on the end of each wire and connect to the sensor?
ClubCalibra.net
ClubCalibra.net
 
Posts: 15
Joined: Sun Aug 30, 2015 6:46 pm
Location: Surrey/Kent

Re: Outside temperature sensor

by rich30mex » Thu Sep 03, 2015 7:41 am

It should just be 2 wires just cut the plug off the new sensor and just block connect them or solder a new plug and short lenghr of wire on from an old harness if you want it doing correct
THE TEA BAG Calibra l,e number 4
THE WELLY rio verdi ecotec on a N reg
UNCLE ALBERT gray 8v on a J reg

Best engine bay 2011
Best engine bay 2014
Best in show 2016
Treasures cup 2016
Best engine bay 2017
Best modern retro total retro 2018

mag features
practical classics
modern classic
performance vauxhall


Have car have cloth will clean need life
User avatar
Events Coordinator
Events Coordinator
 
Posts: 3165
Joined: Sat Jan 03, 2009 11:19 am
Location: a hovel


Who is online
Users browsing this forum: No registered users and 14 guests