Vibration coming from various places..

**vinny_69** · by **vinny_69** » Wed Jul 16, 2008 12:55 pm

easy if you have an angle grinder that works :oops:

only takes about ten mins each side.
have you had a look on your motor see if they have snapped?

**DC 12v** · by **DC 12v** » Wed Jul 16, 2008 12:57 pm

One had a little while back, so I threaded a temp bolt in there.. chances are that one has snapped too now though. Didn't think it could cause such uncomfort in the drive.

*face>palm*

**vinny_69** · by **vinny_69** » Wed Jul 16, 2008 12:59 pm

its an easy fix mate and cheap too

**DC 12v** · by **DC 12v** » Wed Jul 16, 2008 1:02 pm

I've made my checklist, bring on payday!

Thanks Vinny.

**vinny_69** · by **vinny_69** » Wed Jul 16, 2008 1:11 pm

no prob mate glad to of helped

**DC 12v** · by **DC 12v** » Sun Jul 20, 2008 9:41 pm

Tried tightening up those big ol' nuts in the engine bay today, they weren't locked tight, but certainly was a job getting them any tighter than they were..

Unfortunately progress is minimal, as I've spent the weekend away..

Balancing is to be done next weekend.

Vibration coming from various places..

About Us

Join ClubCalibra!